Hot water heaters are one of a property’s most diligently working devices. Day or night, it’s churning out perfectly heated water at any time when you desire it. So when it suddenly is no longer working effectively, most of us have the tendency to worry.

Thankfully a nonfunctioning water heater does not constantly mean a pricey repair work. Prior to making an emergency call to Haynes Plumbing, we suggest checking the trouble yourself first.

Rockville Water Heater Repair Troubleshooting

Pilot Light CheckRockville Water Heater Repair

For gas water heaters first get rid of the small panel which is situated on the bottom of the appliance and look to observe if the pilot light is lit.
See if will relight if it is not ignited. If it remains lit, one should be able to notice that the water heater ought to begin operating correctly once more. The pilot light may need cleaned or the thermocouple may require to be replaced in the event the pilot light will not remain ignited.

Thermocouple Replacement

The name thermocouple may perhaps seem like a incredibly complex term, however it’s an element on ones water heater that can easily be replaced. Haynes Plumbing would highly recommend having us do the replacement but the tips below are for instructional objectives.

Consult the owner’s handbook. It must have directions for how you can remove and replace the thermocouple.
Turn off the gas before removing anything at all from the water heater.
Following the guidelines in your user’s guide, get rid of the thermocouple by removing it from both sides of the pilot light. The new thermocouple on the water heater is required to be cut to the appropriate length.
The gas may then be switched back on and examine for leakages, then the pilot light can be lighted once again.

Press the Water Heater Reset Button

For property owners with an electric water heater, look for the place of the reset button and push it until a click is noticed.
If a click is not noticed, or it fails to reboot the water heater, reset the breaker.
If a breaker reset does not suffice, the thermostat will most likely need changed.

Thermostat Replacement

Both the power to the water heater and the switch on the breaker will need to be turned off. Essential safety with electricity is required to be used!
Use the owner’s manual to locate the thermostat wires, then disconnect them.
Following taking out the thermostat we will examine to learn its problem. If it is malfunctioning, we will have to replace it.

Heating Element Replacement

While the power is still off, the access panel on the water heater may be opened up.
The terminal screws may be loosened and the wires can be drawn far from the heating element.
We’d after that analyze each component of the element to check if they are faulty, and change them as needed.

These water heater troubleshooting methods help get ones heater working once again. Haynes Plumbing is always here to assist, and so don’t hesitate to contact us today for any Water Heater Repair Rockville MD help.